How To Change A Thermostat Battery
How To Change A Thermostat Battery. Grab the thermostat top to bottom and pull it off the wall. Turn the thermostat cover over to see where you can insert new batteries.
Put the new batteries into slots with + sign facing upward, unless the thermostat is marked differently. You may need to slide it up the wall plate before it will detach. Use a small screwdriver to pry out the old batteries and remove them entirely.
You Can Usually Remove It By Pushing A Tab To The Side, Though Some Units Will Require A Screwdriver.
You may need to slide it up the wall plate before it will detach. The factory settings for your thermostat will be restored. To remove the room thermostat from the wall mounting plate:
Put The Batteries Back In And Make Sure They Are Fully Seated And Facing The Right Way.
If are unable to do so, then slide it upwards and pull it off. In a lot of ways, replacing the batteries on a honeywell. If flat batteries have been the cause of the problem the thermostat will automatically reset when power from the new batteries is restored.
Grab The Thermostat Top To Bottom And Pull It Off The Wall.
Put the thermostat’s housing back onto the. Push the thermostat display back onto the base until it clicks into place. Separate the device from the wall plate.
Turn The Thermostat Circuit Breaker To The Off Position.
The way you remove thermostat housing may vary with each thermostat. Remove the batteries (you may need a flathead screwdriver to pry them out). If your thermostat is not working after you change your batteries you most likely installed the wrong type of batteries or installed the batteries incorrectly.
The Battery Compartment Will Be Located On Either The Front, Side, Or Back Of The Thermostat.
How do i change the battery on a carrier infinity thermostat?justanswer customer: Pull the wall thermostat housing off of its wall mount plate. At this point, you can remove the old batteries and insert new ones.
Comments
Post a Comment